

#PC5010 DISPLAY MASTER CODE CODE#
To secure thesystem, close all doors and windows and cease all motion in areas covered bymotion detectors.When this message appears, use the arrow () keys to verify that the system isclear of troubles and that no zones are bypassed unintentionally (see “ViewingTrouble Conditions” on page 12 and “Zone Bypassing” on page 11).If this display is showing, the system is in the Ready state and may be fully armed.To arm the system, enter your access code.Once the correct access code has been entered, the display will be as shown. The exit delay time can be changed by your installer.Arming from an LCD Keypad:Secure SystemBefore ArmingEnter Code toArm System Enter Code toArm SystemExit Delay inProgressEnter Code toDisarm System* WARNING *Bypass ActiveWhen this message appears, one or more zones are not secured.


At the end of the exit delay period, the Ready light will turn OFF and thesystem will be armed. Exit the premises through the door indicated byyour installer as the Exit/Entry door.The panel will provide an exit delay period, indicated by keypad beeps, for you to exit the premiseswithout causing an alarm. If the correct access code is entered, the keypad sounderwill beep quickly and the Armed light will come ON. If this occurs, pressthe key and re-enter your access code. If the access codewas entered incorrectly, the keypad buzzer will sound steadily for two seconds. As each digit is entered, the keypad sounder will beep. Thesystem cannot be armed unless the Ready light is ON indicating that all zones are closed and thesystem is in the Ready state.Enter your access code. If the Ready light is OFF, check to see that alldoors and windows are closed and that motion is stopped in areas covered by motion detectors. Ask your installer for more information regarding access codes.Arming the SystemArming from an LED Keypad:If the Ready light is ON, the system is ready for arming. All keypad entries are made by pressing one key at a time.All access codes can be programmed by following the procedure outlined in “Programming Securit圜odes” on page 7.NOTE: An access code can be a four or six digit number depending on how your installer hasprogrammed your system. The Master Code will be supplied to you byyour installer. There are 33 access codes available: oneMaster Code and 32 access codes.Only the Master Code can be used to program additional security codes and to change other systemfeatures as well as to arm and disarm the security system. Access CodesAccess Codes are used to arm and disarm the system.
